Voip > Help > Residential > Installation > Networking > Q&A

How do I set the Westell modem to Bridged Ethernet Mode?

NOTE: You will unable to access the Westell interface if using bridged mode in conjunction with another router.

1. Make sure you have powered off (and unplugged) all network devices (including your computer)
2. Connect the Westell directly to the PC and power up the modem only. Wait until it is completely finished its startup and press the reset button on the back of the modem. Wait until it is completely finished its restart, then power up the PC.
3. Point your Internet Web Browser to "192.168.1.254" or "launchmodem." If you are unable to access the interface make sure your network card is set to "Obtain an IP address automatically."
4. Click on Expert Mode.
5. Click on Configure from the menu and then Connection in the sub-menu.
6. Select "Bridged Ethernet" from the Protocol pull down.
7. Click on Save and restart the connection at the bottom. This will automatically restart the modem and the interface will return after the changes are saved.
8. Your Westell is now in "Bridged Ethernet" mode

 

Other Installation Help Topics

• How do I configure the phone adapter with an Actiontec modem?
• How do I set the Westell modem to Bridged Ethernet Mode?
• Where can I find my voip adapter’s MAC address?
• My phone adapter will not work behind my router/firewall!
• I can make outgoing calls, but I have no audio on incoming calls!
• What is an IP Address?
• What happens to my IP address if I change the location of my voip internet phone adapter?
• Can I use an IP phone or VoIP Phone with my account?
• Introduction to your Linksys® Phone Router (What is a “Router?”)
• How do I resolve sound quality issues on my phone calls?
• Does voip.com service require a fixed (static) IP address?
• How do I enable port forwarding on a Westell modem?